Installation Guide

Installation and configuration for Windows
4-4 Installation Guide
• A Winsock compliant
Using the LPR gateway
If your network uses TCP/IP, you print through the LPR
gateway.
Occasionally, large jobs, jobs containing a large number of
graphics, or jobs that are printed on busy networks may
cause the LPR connection to time out. If a time-out occurs,
you may increase the LPR time-out values at the Windows
workstation in order to allow these jobs to print. Set the
default time-out values (in seconds) in the XDOCSUB.INI file,
as follows:
1. Locate the XDOCSUB.INI file on your workstation.
• For Windows 95/98, this file should be in the
c:\windows directory.
• For Windows NT/2000, this file should be in the
c:\WINNT directory.
2. Use a text editor to add the following section and keyword
value pairs to the XDOCSUB.INI file:
[LPR Options]OpenPrintTimeOut=25
ClosePrintTimeOut=20
SendPrintTimeOut=20
RecvPrintTimeOut=20
OpenVerifyTimeOut=15
CloseVerifyTimeOut=5
SendVerifyTimeOut=10
RecvVerifyTimeOut=15
3. Save and close the XDOCSUB.INI file.
Removing previous versions
Before you install or upgrade any XPPS components, remove
any old versions that are installed, and restart your computer.
Use the instructions in this section to do so.
NOTE: If you are upgrading the Windows NT 4.0 custom
Xerox PostScript driver, it is recommended that all older
versions of the driver be deleted prior to performing the
upgrade.