Printer Accessories User Manual

Step-by-Step Instructions

(PRINT this set of instructions to follow every time you refill your cartridge)

Xerox 8R7638/ 8R7659/ 4004 Cartridges

Xerox Xj4C/ Document Work Centre 450C/ 4004/ Home

Work Centre Printers/Texas Instruments Micromarc Printers

Items needed: gloves, #2 refill station, hand-drill, Flat aluminum plugs, dye-based

black ink, paper towels, review hints & tips and check list

Bottle Seal: Unscrew lid on ink bottle. Puncture silver seal with needle top

making a small hole in the center of seal. Tightly screw on dispensing tip. Rinse

dispenser tip before using dispenser tip with another color. Rinse tip with water

until the water runs clear. Pull plastic tip cover off of tip of syringe to pour ink.

1. Make a filling hole on the front of the cartridge 1/2" from the top using the thumb drill

provided.

2. Insert the Black Dye filling needle through the hole and push towards the center of the

cartridge. The cartridge contains felt. Stop inserting the syringe when the needle touches

the felt. The needle is in as far as it can go.

3. Slowly inject up to 20 ml. of ink or until ink appears at the filling hole.

4. Seal the filling hole with the aluminum tape provided.

5. Xerox_8R7638 Check the ink flow by gently pressing a dry paper towel against the

PAGE 1
Step-by-Step Instructions (PRINT this set of instructions to follow every time you refill your cartridge) Xerox 8R7638/ 8R7659/ 4004 Cartridges Xerox Xj4C/ Document Work Centre 450C/ 4004/ Home Work Centre Printers/Texas Instruments Micromarc Printers Items needed: gloves, #2 refill station, hand-drill, Flat aluminum plugs, dye-based black ink, paper towels, review hints & tips and check list Bottle Seal: Unscrew lid on ink bottle.
PAGE 2
printhead. You should see a line or dot of Black ink. If not, gently press a warm, wet paper towel against the printhead until the black is visible. 6.) When black is visible on paper towel, place cartridge back into the printer and run 1 to 2 print tests. Or print 2 pages at this test site http://www.inkonline.net/support/blackinktest Black ink test For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.