Owner's Manual

Network Installation
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
98
13. Click the [Reboot Machine] button and click [OK] to reboot the machine. The network controller
takes approximately 5 minutes to reboot and network connectivity will be unavailable during this
time.
Create a Device Description
Create a device description from your AS400 terminal's command line.
1. Select the F-4 key to prompt the CRTDEVPRT command. Enter the following parameters:
Device Description: Xeroxprinter
Device Class: *lan
Device Type: 3812
Device Model: 1
2. Press [Enter] to continue, and enter the following parameters:
Lan Attachment: *IP
Port Number: 9100
Online at IPL: *yes
Font Identifier: 11
Form Feed *autocut
Note: For some versions of AS400, the default may match some of these parameters.
3. Leave all other parameters at the default value, press [Enter], and enter the following parameters:
Activation Timer: 170
Inactivity Timer: *sec15
Host Print Transform: *yes
4. Press [Enter] to continue, and enter the following parameter: Manufacturer Type and Model:
*hp5si
5. Leave the remaining parameters set to their default values and press [Enter] to continue. Enter
the following parameters: Remote Location: Enter the IP address of the printer.
User defined options: *IBMSHRCNN
System driver program: *IBMSNMPDRV
6. Leave all other options set to the default values. Press [Enter], A message will indicates that you
have created the device Xerox printer.
7. Power on the device and start a print writer. Then place a spool file in the appropriate queue to
test the printer.
AS400 Printing using LPR (CRTOUTQ) - Optional
Creating a remote queue (LPR) on the AS400
1. At the command line, issue CRTOUTQ and press F4, then F9 for additional parameters. The setup
is as follows:
Note: ONLY CHANGE THE PARAMETERS IN BOLD.
• Output queue: queue name
•Library: Library name
• Maximum spooled file size