Owner's Manual

Device Connection and Quick Setup
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
8
Device Control Panel Overview
Initial Connection
Follow these steps to physically connect your device to the network.
1. Connect the Power Cable
Ensure the device is connected to a suitable power supply and that the power cord is fully plugged
in to the electrical outlet.
2. Connect the Ethernet Cable
Connect a 10/100/1000 BaseT Ethernet cable to the Ethernet port at the rear of the device and
the other end of the cable to your network port.
3. Insert the SIM Card
Insert the SIM Card before powering On the device, the SIM slot is located at the rear of the
device.
4. Power On the Device
The Power On button is located at the left-side of the device.
Install Wizard
If this is the first time the device has been powered on, the Install Wizard will run. If this screen does
not appear, proceed to Network Connectivity in this chapter.
The install wizard will prompt you with questions to help with the configuring of your device.
Before the Install Wizard
1. At the device, before the Install Wizard begin, the Installed Optional Hardware screen displays,
touch the [Next] button.
2. The Machine Location screen displays, select one of the following location and to allow the ink
sticks to heat before the machine can be used:
Services
Home
Job Status
Machine Status
Display and Touch
Screen
Log In/Out Help
CancelNumeric
Keypad
StopStart Power
Clear AllInterrupt
Printing
Language
Services
Dial Pause