Owner's Manual

Security
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
165
System Timeout
This feature resets the system to the default state after a set amount of time elapses without any user
interface activity.
If users do not interact with Internet Services web pages within the time defined, logged in users will
be logged and all unsaved settings will be lost.
When Authentication and/or Accounting is on (a user is logged in) and the System Timeout timer
expires and if no partial job exists, the system shall log the user out (without warning or notification)
and perform a Reset to Default.
At your WorkStation:
1. Open the web browser and enter the IP address of the device in the Address bar, and press
[Enter].
2. Click the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [Security] link.
6. Select [System Timeout] in the directory tree.
7. System Timeout screen displays.
a. In the Web System Timer area, for [Minutes], enter the time the system will wait before a
logged in user will be logged out. You can enter a time from six to 60000 minutes.
b. In the Touch User Interface System Timer area, enter the value in the [Minutes] field. The
range is 0 - 60 minutes. From the [Seconds] drop-down menu, select the required value.
If the user does not interact with the User Interface within the time defined, settings will be
reset to default setting and if the the user is logged in, they will be logged out.
8. Click on the [Apply] button.
9. Click on the [OK] button when you see the message “Properties have been successfully
modified”.