Owner's Manual

Device Connection and Quick Setup
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
16
To Setup HTTP
The Internet Services HTTP screen enables the System Administrator to specify the Keep Alive
Timeout, Maximum Connections, Port Number and Secure HTTP (SSL) settings.
1. At your Workstation, open the web browser, enter the IP Address of the device in the Address bar,
and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [HTTP] in the directory tree.
8. In the Configuration area:
a. The [Keep Alive Timeout] setting determines how long the device's Internet Services pages
will wait for a response from a connected user before terminating the connection. Enter the
required number of seconds (1 - 60) in the [Keep Alive Timeout] field.
Note: Generally, user connections will be adversely affected (slow or kept busy) if the Keep Alive
Timeout is set for a longer period of time.
The [Maximum Connections] setting is the maximum number of simultaneous connections that
can occur at any given moment to Internet Services. Enter a number from 8 - 32 to indicate the
maximum number of clients that can be connected (for example, with open sockets) to the HTTP
server at any one time in the [Maximum Connections] field.
Note: In order for the device to operate in Secure HTTP (or HTTPS/SSL) mode, the device must
possess a correctly configured Machine Digital Certificate. For information on Machine Digital
Certificate, see Machine Digital Certificate Management on page 151.
b. For Secure HTTP (SSL), select [Enabled] to set the HTTP Security Mode.
c. Change the Port Number if required. The default is 443.
d. Click on the [Apply] button to accept the changes.
Configure Network connectivity Protocols with Internet Services
Internet Services is a series of web pages, hosted on the embedded HTTP server of the device, allowing
configuration of services and settings using a web browser.
Refer to the Protocols section of this guide and follow the instructions to configure protocols.
To configure individual protocols only, using your web browser, perform the following steps:
1. At your Workstation, open the web browser and enter the IP address of the device in the Address
bar, and press [Enter].
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.