Owner's Manual

General Setup
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
22
8. In the General area:
a. For Configuration Report, check the [Print at Power on] checkbox to enable a configuration
report to print at power on.
b. For Configuration/Information Pages Report, check the [Restrict to SA] checkbox to restrict
Configuration Report and Information Pages to the System Administrator.
c. Enter the time to pass, in minutes, for the device to timeout in the [Timeout] field. The range
is 0-7200, the default is 30 minutes.
9. In the Banner Sheet area:
a. For Print Banner Sheets, select [Yes] to allow a banner sheet to print with every print job.
b. For Allow the Print Driver to Override, select [Yes] to allow the print driver to override the
banner sheet option.
c. For Banner Sheet Identification, select one of the following:
• Job Owner User ID and Job Name
• Xerox Network Accounting User ID and Job Name
• Generic User ID and Job Number
10. In the Secure Print area:
The Secure Print requires a user to be authenticated as the owner of a print job using a passcode,
printing will only begin when the secure passcode is entered at the device,
a. For Secure Print Passcode Length, enter the minimum required length of the Secure Print
Passcode.
b. For Release Behavior, select one of the following:
• Release all owner’s jobs with passcode - this will release all jobs associated with the
user, with the supplied passcode.
• Release only the selected job - this will release only a selected job with a supplied
passcode.
11. In the Defaults area, select the required settings for the following options:
• Copies - allows you to set the default number of copies output by the device, the range is 1-
9999.
• Job Type - allows you to select the default job type.
• Paper Size - allows you to specify the default paper size from the drop-down menu.
• Paper Color - allows you to specify the default paper color from the drop-down menu.
• Paper Feed Edge Default - allows you to select either long or short edge feed.
• 2 Sided Printing - allows you to select either 1-Sided Print, 2-Sided Print or 2-Sided Print Flip
on short edge.
• Output Color - allows you to select whether the output is color.
• Collate - allows you to enable or disable the collation.
• Staple - allows you to set the default staple position.
12. Click on the [Save] button to return to the Print Protocols screen.
13. Click on the [Configure] button next to the IP (Internet Protocol), to enable
on the device to
support your network environment.
14. Enter the information for your chosen protocol. If you need more information on how to configure
protocol information refer to Network Installation on page 63.