Owner's Manual

General Setup
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
24
c. By default all features are selected, click on the [Clear All] button, and check the following
feature checkboxes to select the features that you wish to clone:
d. To select all the features, click on the [Select All] button.
e. Click on the [View feature Details] link to view the specific parameters that can be cloned for
any of the feature.
f. Click on the [Clone] button.
8. In the Cloning Instructions area:
a. Right-click on the [“Cloning.dlm”] link that appears and select [Save Target As].
b. A dialog box will prompt you to specify a name and location for the cloned file. Ensure the
extension reads ‘.dlm’.
c. Click on the [Save] button. The ‘.dlm’ file can now be used to clone other devices.
To Install the Clone File on Another Device
Note: This procedure will cause the device to reboot and will be unavailable over the network for
several minutes.
1. Click on the [Status] tab.
2. Select [Welcome] in the directory tree.
3. Click on the [I Have A Cloning File] button.
4. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
5. Click on the [Login] button.
6. In the Install Clone File area, click on the [Browse] button.
7. Locate your file and click on the [Open] button
8. Click on the [Install] button.
The device will be unavailable over the network for several minutes. Once rebooted a Configuration
Report will print, if enabled.
•Accounting •Security
• Administration • SMart eSolution
• Audit Log • System Disk
• Authentication & Authorization
Configuration
•Power Saver
• Connectivity Settings • Print Settings
• E-mail • Workflow Scanning
•Fax •Templates
•Internet Fax •Device Upgrade
• Internationalization • Web Services
• Job Management • Public Address Book