Owner's Manual

Network Installation

Xerox ColorQube™ 9201/9202/9203

System Administrator Guide

TCP/IP Settings

This section explains how to set up the device to operate in a Windows TCP/IP environment. The

following information is provided:

• IPv4 on page 67

• IPv6 on page 68

• Supporting LPR Printing on page 70

• Configure Raw TCP/IP Printing on page 71

• Configure SLP on page 72

• SNMP on page 73

• SSDP on page 78

• Microsoft Networking on page 78

• AppleTalk on page 80

• Create an IPP Printer (Internet Printing Protocol) on page 80

The device supports IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.

IPv4 Settings can be configured directly at the device user interface, or remotely, via a web browser

using Internet Services. IPv6 can only be configured using Internet Services. To configure TCP/IP

Settings using Internet Services, see Configure TCP/IP Settings using Internet Services on page 67.

Configure Static Addressing using the Device

Information Checklist

Before starting the procedure, please ensure the following items are available or have been performed:

• Existing operational network utilizing the TCP/IP protocol.

• Ensure that the device is connected to the network.

• Static IP Address for the device.

• Subnet Mask Address for the device.

• Gateway Address for the device.

• Host Name for the device.

Enter a Static IP Address

1. At the device and press the <Log In/Out> button to enter the Tools pathway.

2. Enter the Administrator’s User Name [admin], touch [Next], enter Password [1111], touch

[Enter].

3. Press the <Machine Status> button, and then the [Tools] tab.

4. Touch [Network Settings].

5. Touch [TCP/IP Settings].