User's Manual

6. Reinstall the cartridge unit to its original position in the finisher.
7. Close the right cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.
Standard Finisher Plus fault codes
Finisher Module fault codes
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
013-108
Cause: The transport in sensor in the Finishing Transport did not switch ON within a
specified amount of time.
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
013-109
Cause: The transport exit sensor in the Finishing Transport did not switch ON within
a specified amount of time.
Remedy: Perform the following:
• Check for any obstructions or paper jams in the Finishing Module and Finishing
Transport paper paths and clear them.
• If necessary, power Off/On the machine, and if necessary, resend/restart your print
job.
• If the fault persists, contact the Customer Support Center.
18-37Xerox
®
D110/D125/D136 Printer
User Guide
Standard Finisher Plus