User's Manual

Warning
Precision components and high-voltage power supplies are used on the machine. Never
open or remove machine covers that are screwed shut unless specifically instructed in
the User Guide. A high-voltage component can cause electric shocks. When opening the
panels and covers that are screwed shut to install or detach optional accessories, be sure
to follow instructions in the User Guide. Do not try to alter the machine configuration
or modify any parts. Doing so might cause machine malfunction or fire.
RemedyCheckSymptoms
Turn the power switch on.Is the power switch on the
machine turned off?
Power is not
switched ON.
Turn the power switch off and then firmly plug
in the power cord. Then turn the power switch
on.
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine or the rear of the
rack?
Make sure that the power supply is 200 -240 V
(volts), 15 A (amperes).
Make sure that power of capacity compatible
with the specified maximum power
consumption of the machine (2.8 - 3.1 KVA) is
being supplied.
Is power of the correct
voltage being supplied?
The machine is in the Power Saver mode. Press
the Power Saver button on the Control Panel
to cancel the Power Saver mode.
Is the Power Saver button
on?
Display is dark.
Adjust display brightness using the Brightness
dial.
Is the brightness dial set too
low?
Follow the instructions displayed.Is a message displayed on
the Control Panel?
Unable to print,
or
unable to copy.
Press the Machine Status button and from the
Printer Mode, select Online.
Is the printer mode Offline?
Turn the power switch off and then firmly plug
in the power cord. Then turn the power switch
on.
Is the power cord
disconnected from the
machine or the rear of the
rack?
10-25Xerox
®
D110/D125/D136 Printer
User Guide
Problem solving