User's Manual

Specifying print format parameters
Using LCDS Print Description Language 4-89
OUTPUT TRANS
Specifies whether or not transparencies are used in the print job.
Syntax OUTPUT TRANS = {YES | NO}
Options
Default NO
OUTPUT TRANS
parameter: points
to note
• DP 100/115/135/155/180 EPS only: Transparencies cannot
be handled by the high capacity feeder/stackers. Due to this
restriction, transparency jobs must be fed from the processor
feeder trays (trays 1 and 2) and delivered to the sample tray.
(The DP 75/90 EPS can feed transparencies from any tray.)
• If TRANS is specified in a job, these parameters
automatically go into effect:
OUTPUT UNITS
Defines the size in dots of the unit of measure that will be used to
position a graphic that is referenced by the OUTPUT IMAGE
parameter or an IMAGE, ALTER, or GRAPHIC DJDE.
Syntax OUTPUT UNITS = size
Table 4-79. OUTPUT TRANS parameter options and
definitions
Option Definition
YES Indicates that transparencies will be used in the job.
NO Indicates that transparencies will not be used in the job.
OUTPUT DUPLEX = NO;
ACCT USER = TRAY;
OUTPUT BFORM = NONE;
RPAGE SIDE = NUFRONT;