User's Manual

Using Dynamic Job Descriptor Entries (DJDEs)
5-50 Using LCDS Print Description Language
JDL DJDE: points to note
• The JDLid.JDL file must exist on the print server disk.
• If there is no delimiter between the JDL DJDE and the JDL
identifier (JDLid), a syntax error is displayed.
• If only a JDL DJDE (no JDE DJDE) is specified in the DJDE
packet, the system uses the JDE most recently specified in a
DJDE in this report. If no JDE was specified in any DJDE, the
system uses the JDE that is specified on the LCDS Setup
window.
• In a DJDE packet containing a JDL DJDE, other record or
page oriented DJDEs override parameters specified in the
indicated JDL.
• Record length for the job does not change when a JDL is
switched by a JDL DJDE.
LOGO DJDE
Specifies the name and location of logos that will be printed on a
page or on all pages of a report.
Type Record oriented
Syntax {(name, vpos [units], hpos [units] [, H] [, (INKS, inkref
1
[,
inkref
2
])]) | (name, HERE [, (VADJ, [{+ | –}] tvalue [units]]) [,
(HADJ, [{+ | – }] tvalue [units])] [, H] [, (INKS, inkref
1
[, inkref
2
])])}
Options
Table 5-41. LOGO DJDE options and definitions
Option Definition
name Name of a logo that will be imaged.
vpos vertical position
Specifies the vertical position of the top edge of the logo, as a downward offset,
relative to 0,0 on the current physical page (the position that would be specified
by a PDE BEGIN of 0,0 and a PDE PMODE value, PORTRAIT or
LANDSCAPE, that is currently in effect).
hpos horizontal position
Specifies the horizontal position of the left edge of the logo, as a rightward
offset, relative to 0,0 on the current physical page.