User's Manual

Using Dynamic Job Descriptor Entries (DJDEs)
5-68 Using LCDS Print Description Language
Options
SHIFT DJDE: points to note
• The SHIFT DJDE takes effect at the next physical page
boundary.
• The resolution for both v
1
and v
2
is 1/300 of an inch for all
printers.
• If the origin of a print line falls off the page, the printing
system prints as much of the line as possible.
• Graphics and logos are not allowed to start off the page. If
they are positioned at a point that is off the page, an error
message is displayed.
SIDE DJDE
Specifies repositioning of the next logical page so that it is the
first logical page on the given side of a physical sheet.
Type Page oriented
Syntax SIDE = {sideopt | offsetopt | (sideopt, offsetopt)}
Table 5-57. SHIFT DJDE options and definitions
Option Definition
v
1
value 1
An integer value in dots for the amount of shift on the simplex page or the odd
(front) side of the duplex page. (Each dot is 1/300 of an inch.)
The range for v
1
is –75 to 75.
v
2
value 2
A value in dots for the amount of shift on the even (back) side of a duplex page.
The range for v
2
is –75 to 75.
YES Specifies that a shift occurs. A standard size shift occurs if YES is specified
(v
1
=75 and v
2
= 75).
NO Specifies that no shift occurs (v
1
=0 and v
2
=0).