Operating Guide

5-16 DocuTech 128/155/180 HighLight Color Operator Guide
Technical information
Finisher satisfaction guides
NOTE: Production publisher configuration only
The following guides summarize the stacker, stitcher, binder, and
top tray capabilities.
Table 5-11. Stacker capacity
Stock
Reliable stacking may be
expected
Less reliable stacking may be
expected Suggested alternatives
Size 8 x 10 inches to 9 x 14
inches (203 x 254 mm to
229 x 356 mm)
Use the top tray for larger
sizes
Weight Substance 16 to 20 (60 to
75 g/m2)
Weights outside the limits
shown are not recommended.
Set or stack
size
Substance 16 to 20 (60 to
75 g/m2)
Over substance 20 (75 g/
m2) stock as sets or stacks
increases the likelihood of
bindexer jams.
When using copy paper
heavier than substance 20 (75
g/m2), limit the stack or set
size by dividing the set into
parts. Combine prints when
completed and finish offline, if
required. For collated
unfinished sets, the maximum
sheet capacity of the bindexer
can be set to between 50 and
125.
Stacker
capacity
Unfinished sheets:
3300 sheets, substance
16 (60 g/m2)
3000 sheets, substance
20 (75 g/m2)
2500 sheets, substance
24 (90 g/m2)
1875 sheets, substance
32 (120 g/m2)
1360 sheets, substance
110 (200 g/m2)
To allow a continuous run,
unload outer stack before
inner stack reaches capacity.
Type or
condition
Xerographic bond paper in
good condition
Drilled paper
Slightly curled paper Do not use excessively curled
paper.
Transparencies must contain
some opaque sheets to avoid
finisher jams.
Stock not defined here is
included in the “Using various
stocks” section in this guide.