User's Manual

4-2 System Guide
Finishing
Creating jobs to use subset finishing
It is important that jobs intended to be printed using subset
finishing be enabled with the following:
• PostScript code (using the “setpagedevice” operator)
• Variable Data Intelligent PostScript PrintWare (VIPP) version
2.0 or later.
NOTE: Subset finishing can also be performed at the FreeFlow
workstation through the Document Scan and Make Ready
application.
Subset offset (Page Level Jog)
The printer has the ability to offset on a page level. This support
allows VIPP to be utilized for offset type applications. This ability
permits jobs to be sent as one larger file with page level offset
commands.
The term “Jog” is used to initiate offset behavior.
• setpagedevice jog 0 (The offset command is “OFF”).
• setpagedevice jog 3 (The offset command is “ON”).
A job with a multiple copy count with a “jog 3” should force offsets
between each distinct set. A job with a copy count of 1 can contain
“jog 0” or “jog 3” on a page by page basis. The system will
alternate offsets between each alternating jog 3 and jog 0
command.
The following information should be considered when using the
“Jog” command:
• The first jog command on a page will be honored and all
others will be ignored.
• Multiple cases of jog 3 without the corresponding job 0’s will be
ignored.
• The Printer Manager’s setting of offset “ON” or “OFF” should
not impact the action of the PDL level jog commands. For
example, if the Printer Manager’s offset is set to “OFF” and a
job has a jog 3, then the sets should be offset from one
another.
• The DT/DP 75/90 allows subset offsets to the top tray.
However, the 61xx is not mechanically capable of jogging to
the top tray.