User Guide

4
4-42 Performing Setup from the Control Panel
Administrator E-mail Domain Name
Enter the name of the domain in which the administrator has an account. This is
typically the part of the e-mail address that follows the @ symbol. For example, in the
address [e-mail], the domain name is test.com.
You can enter a maximum of 19 characters.
The administrator authorizes a unique e-mail address to remotely administer the
E-mail Services via e-mail. This includes the Fiery Address Books, designed for use in
sending scan files to a particular e-mail address the user chooses at the EX7750
Control Panel, and in controlling user access to E-mail Services. If an error occurs
while you are executing a job via e-mail, the e-mail service sends an error message to
that administrator e-mail address. The administrator can authorize additional e-mail
addresses as administrators from this e-mail address.
Timeout (sec)
30–300 [60]
Enter the length of time, in seconds, that the EX7750 should try to connect to each
e-mail server before determining that the connection is unsuccessful.
Polling Interval (sec)
1–3600 [15]
If you have enabled auto-checking for new messages in the previous option, enter
the interval in seconds at which the EX7750 should automatically check for
new e-mail.
NOTE: To set up e-mail services for “Sending Methods,” refer to the printer network
documentation. To use Email services for both the EX7750 and “Sending Methods,”
separate accounts are required. Set up both accounts from their respective setup
menus.