User Guide

5-9 Network Setup

Adapters/Ports

In local Setup only, the installed network boards are displayed. You cannot change this

information. From remote Setup, you can enable Ethernet. These options are

described in the following section.

Ethernet (Port Setup)

Enable Ethernet—Select to connect the EX7750 to an Ethernet network.

Transmission Speed—Select an appropriate setting according to the settings of the

network to which the EX7750 is connected.

NOTE: When you select Auto Detect, make sure that the auto-negotiation settings for

speed and duplex are conﬁgured for the network port to which the EX7750 is

connected. Similarly, when you select a different setting such as 100 Mbps

Full-Duplex, make sure the same settings are conﬁgured for the network port.

NOTE: The 1 Gbps (gigabit per second) setting is full-duplex.