User Guide

7-9 System software

After you power on, the EX7750 organizes the software on the system and then

reboots once (twice, if the monitor/keyboard/mouse option is enabled). Several

messages display indicating that the backup software is being installed or restored.

This segment takes approximately 10 minutes. Wait for the system to boot completely

and the Idle screen to appear on the Control Panel.

11. At the message “Please insert CD 3”, insert CD 3, and then close the drive drawer.

CD 3 installs automatically. Installation takes approximately one minute.

12. At the message “Remove CD and recycle power”, remove CD 3. Then, using the power

switch on the back panel, power off the system, wait 10 seconds, and then power the

system back on.

After you power on, the EX7750 applies the content installed from CD 3 and then

reboots once more. Wait for the system to boot completely and the Idle screen to

appear on the Control Panel. This segment takes approximately six minutes.

13. Reconnect any USB devices or dongles that you may have removed earlier.

14. Conﬁgure Setup using the Conﬁguration page you printed earlier.

15. Reinstall fonts, user software, or custom simulations that may have been deleted

when you restored system software.