User Guide

7-12 Administering the EX7750

10. At the message “Remove CD and recycle power”, remove CD 3. Then, using the power

switch on the back panel, power off the system, wait 10 seconds, and then power the

system back on.

After you power on, the EX7750 applies the content restored from CD 3 and then

reboots once more. Wait for the system to boot completely and the Idle screen to

appear on the Control Panel. This segment takes approximately six minutes.

11. Reconnect any USB devices or dongles that you may have removed earlier.

12. Conﬁgure Setup using the Conﬁguration page you printed earlier.

13. Reinstall fonts, user software, or custom simulations that may have been deleted

when you installed system software.