User Guide

1-12 Connecting to the Network

Ethernet connection

For Ethernet connections, the EX7750 supports Unshielded Twisted Pair (UTP,

4 pairs) cabling, deﬁned as Category 5 for use with 100BaseT and 1000BaseT; or as

Category 3, Category 4, or Category 5 for use with 10BaseT. The cable uses an 8-pin

RJ-45 connector that plugs into the RJ-45 socket on the EX7750.

NOTE: The 100BaseT and 1000BaseT types supported by the EX7750 are 100BaseTX

and 1000BaseTX, respectively, also known as Fast Ethernet. If an Ethernet hub is used,

it must be a 100BaseTX or 1000BaseTX hub. The term “100BaseT” and

“1000BaseT” are used to refer to 100BaseTX and 1000BaseTX, respectively.

TO CONNECT TO THE NETWORK CONNECTOR

• Connect the network cable to the RJ-45 connector on the back of the EX7750.

OTE: Make sure to connect the network cable to the connector marked LAN on the

back of the EX7750. The connector marked with the copier illustration is used for the

connection to the printer. See the illustration on page 1-11.

You must use a Category 5 unshielded twisted pair network cable for 100BaseT and

1000BaseT.