User Guide

4-18 Performing Setup from the Control Panel

Port Setup options

Protocol Setup options

Network Setup

Port Setup

To conﬁgure the EX7750, choose the port type you use and enter the settings for

that port. Since network setups are nested, the names of higher-level menus are

shown in this chapter to the left of each menu heading.

Ethernet Setup

Enable Ethernet

Yes/No [Yes]

Select Yes if you have Ethernet cabling connected to the EX7750.

Ethernet Speed

Auto Detect/1 Gbps/100 Mbps Full-Duplex/100 Mbps Half-Duplex/

10 Mbps Full-Duplex/10 Mbps Half-Duplex [Auto Detect]

Select an appropriate setting according to the settings of the network to which the

EX7750 is connected.

NOTE: When you select Auto Detect, make sure that the auto-negotiation settings

for speed and duplex are conﬁgured for the network port to which the EX7750 is

connected. Similarly, when you select a different setting such as 100 Mbps

Full-Duplex, make sure the same settings are conﬁgured for the network port.

NOTE: The 1 Gbps (gigabit per second) setting is full-duplex.

To conﬁgure the EX7750, choose each protocol and enter the settings for that

protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication

simultaneously.

Network Setup

Protocol Setup

AppleTalk Setup

Enable AppleTalk

Yes/No [Yes]

Select Yes if you have an AppleTalk network connected to the EX7750. This setting

enables the EX7750 to communicate over AppleTalk networks.

Exit Protocol Setup

AppleTalk Setup

TCP/IP Setup

IPX/SPX Setup

Protocol Setup