User Guide

4-19 Network Setup options

AppleTalk Zone

List of zones

The EX7750 searches the network for AppleTalk zones in your network segment.

Scroll through the list to select the AppleTalk zone in which you want the EX7750 to

appear. If your segment has only one zone, the EX7750 is assigned to that

zone automatically.

The message “No AppleTalk zone found” may mean your network has no zones, or the

network cable is not connected (see Appendix A). Choose OK to dismiss the message.

TCP/IP Setup options

When you set an IP address, subnet mask, or gateway address for the EX7750 during

Setup, you can allow the EX7750 to get these addresses automatically from a DHCP

or BOOTP server. Turn on or restart the EX7750 and allow it to reach Idle. Make

sure the DHCP or BOOTP server is running, and then perform EX7750 Setup.

To conﬁgure the EX7750 for TCP/IP, choose TCP/IP Setup.

Choose Ethernet Setup and enter the appropriate settings. Choose each network

type you use (Ethernet) and enter the appropriate settings.

Exit Protocol Setup

AppleTalk Setup

TCP/IP Setup

IPX/SPX Setup

Protocol Setup