User Guide

4-20 Performing Setup from the Control Panel

TCP/IP Setup with Ethernet

Enable Auto IP Configuration

Yes/No [Yes]

Select Yes to allow the EX7750 to obtain its Ethernet IP address by searching the

network. Depending on your network and the protocol you select in the following

option (DHCP or BOOTP), the IP address can change. Select No to assign the

EX7750 a static IP address. If you select No, you proceed to the IP Address option,

where you manually set the IP address.

Select protocol

DHCP/BOOTP [DHCP]

This option appears only if you answered Yes to Enable Auto IP Conﬁguration. Select

the protocol over which the EX7750 should search for its IP address. Both DHCP and

BOOTP allow the EX7750 to obtain the Ethernet IP address and Subnet Mask

automatically.

Depending on your network, the EX7750 may be assigned a different address after you

restart the EX7750. With the DHCP setting, the EX7750 can be assigned a different

address even if it is not restarted. Make sure the network is already conﬁgured properly

for the protocol you select.

Network Setup

Protocol Setup

TCP/IP Setup

Ethernet Setup

Enable TCP/IP for Ethernet

Yes/No [Yes]

Select Yes if you have a TCP/IP network connected to the EX7750 over

Ethernet cabling.

NOTE: If you are using TCP/IP for printing from Windows computers, enabling

TCP/IP here also enables you to use Fiery utilities from Windows computers using

TCP/IP protocols.