User guide

Description of Menu Items
Phaser® 6128MFP Multifunction Printer
118
System Setup
System Setup menu is used to make the printer operation settings, such as for alarm and
power saver mode.
Fwd. Set Print Specifies if the outgoing faxes should be printed when they
are forwarded. When set to On, all of the forwarded faxes
are printed.
Fwd. Error Print Prints a report if a forwarded fax is not successfully sent.
Prefix Dial Specifies whether or not to add the prefix number when you
send a fax.
Prefix Dial Num Specifies the prefix dial number, up to five digits. This number
dials before any auto dial number is started. It is useful for
accessing the PABX exchange.
Discard Size Specifies if the printer should discard any excess data at the
bottom of the page.
ECM (Error Correction Mode) If ECM is set to On (the default), it attempts to correct errors
in the fax transmission, caused by problems, such as a noisy
telephone line.
Extel Hook Thresh Specifies the threshold value for the external telephone.
Modem Speed Specifies the fax modem speed.
Country Specifies the country where the printer is used.
Item Description
Power Saver Timer Specifies the transitional time of Power Saver Modes 1 and 2 in increments of 1 minute.
• Mode 1 (Printer)
1 min. to 60 min. (default is 30 minutes)
• Mode 2 (System)
5 min. to 120 min. (default is 30 minutes)
For details, refer to Power Saver Mode on page 22.
Auto Reset Specifies the time the printer waits for further control panel input before
automatically resetting the settings for COPY, SCAN, or FAX and returning to the
standby mode.
Fault Time-Out You can cancel a printing process when it goes beyond a set time period. Set the time
until the print job is canceled. When this timeout expires, the print job is canceled.
• 5 sec. to 300 sec. (default: 30 sec.)
Specifies the amount of time in increments of 1 second the printer waits for
additional data before it cancels the job.
• Off
Cannot cancel.
Item Description