Administrator's Guide
Table Of Contents
- Contents
- Introduction
- Initial Setup
- Network Configuration
- Security
- Printing
- Accounting
- Administrator Tools
- Monitoring Alerts and Status
- Configuring Stored File Settings
- Energy Saving Settings
- System Settings
- Taking the Printer Offline
- Smart eSolutions and Billing Information
- Cloning
- Font Management Utility
- Customizing Printer Contact Information
- Updating the Printer Software
- Date and Time Settings
- Watermarks and Annotations
Network Configuration
Phaser 7100 Color Printer
System Administrator Guide
23
By default, IPv6 is disabled.
CAUTION: If both IPv4 and IPv6 are disabled, you cannot access CentreWare Internet Services.
You must re-enable TCP/IP at the printer control panel before you can access CentreWare Internet
Services. Disabling TCP/IP or changing the IP address also disables any dependant protocols.
Notes:
• The host name is the same for IPv4 and IPv6. If you change the host name for IPv6, the
host name changes for IPv4 as well.
• Enabling or disabling IPv6 will restart the printer when you click Apply.
3. To manually assign an address, select Enabled next to Enable Manual Address.
Type the IP Address and Gateway Address.
4. To allow your DHCP server to assign an IP address to the printer, select Enabled next to Get IP
Address from DHCP.
5. Type the required Domain Name.
DNS Configuration for IPv6
1. To allow the DHCP server to provide the DNS server address, select Enabled next to Obtain IPv6
DNS Server Address Automatically.
2. Type an IP address for Preferred DNS Server, Alternate DNS Server 1, and Alternate DNS
Server 2.
3. Select Enabled next to Dynamic DNS Registration. To replace the existing DNS entry, select
Overwrite.
4. Select Enabled next to Generate Domain Search List Automatically, if you want the domain name
to be searched automatically.
5. Type Domain Name 1, 2 and 3.
6. Type the number of seconds until Connection Time-Out.