Administrator's Guide
Table Of Contents
- Contents
- Introduction
- Initial Setup
- Network Configuration
- Security
- Printing
- Accounting
- Administrator Tools
- Monitoring Alerts and Status
- Configuring Stored File Settings
- Energy Saving Settings
- System Settings
- Taking the Printer Offline
- Smart eSolutions and Billing Information
- Cloning
- Font Management Utility
- Customizing Printer Contact Information
- Updating the Printer Software
- Date and Time Settings
- Watermarks and Annotations
Network Configuration
Phaser 7100 Color Printer
System Administrator Guide
29
LPD
The Line Printer Daemon (LPD) protocol is used to provide printer spooling and network print server
functionality for operating systems such as HP-UX, Linux, and MAC OS X.
Note: For information on setting up print queues on your client system, refer to your client
system’s documentation.
Enabling LPD
1. In CentreWare Internet Services, click Properties > Connectivity > Port Settings.
2. Select Enabled next to LPD.
Note: Disabling LPD will affect clients printing to the printer over TCP/IP using the LPR printing
port.
Configuring LPD
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols > LPD.
2. Type an LPD Port Number between 1 and 65535, or use the default port number of 515.
3. Type the Connection Time-Out.
4. Type the Maximum Number of Sessions.
5. If required, select Enabled next to TCP-MSS Mode.
Note: TCP-MSS settings are common to LPD and Port 9100.
6. If TCP-MSS mode is enabled, under IPv4, type the IP addresses for Subnet 1, 2, and 3.
7. Click Apply.