User guide

Features
28 WorkCentre 3045 Multifunction Printer
User Guide
Note: This menu appears on the WorkCentre 3045NI Multifunction Printer only when the printer is
connected to a wired network connection.
Item Description
Ethernet Specifies the Ethernet communication speed and the modes.
TCP/IP Specifies the TCP/IP settings for the network.
• IP Mode: Dual Stack or IPv4 Mode.
• IPv4: Get IP Address, IP Address, Subnet Mask, or Gateway Address
Protocol Select Enable when using the protocol. Select Disable to make the protocol unavailable.
• LPD: The default setting is Enable.
• Port9100: The default setting is Enable.
• WSD: The default setting is Enable.
• SNMP: The default setting is Enable.
• Status Messenger: The default setting is Enable.
• CentreWare Internet Services: The default setting is Enable.
• LLTD: The default setting is Enable.
• Bonjour (mDNS): The default setting is Enable.
Initialize NVM Initializes network data stored in non-volatile memory. After executing this function and
restarting the printer, all network settings are reset to their default values.
Wireless Network Setup
This menu provides the selections for setting up the printer for wireless network connections.
Note: This menu appears on the WorkCentre 3045NI Multifunction Printer when the printer is not
connected to a wired network connection.
Item Description
Status Displays the status of the wireless connection.
Wireless Setup Specifies the method used for setting up the wireless connection:
• Manual Setup
• WPS
Reset Wireless Resets the wireless network settings to the default settings.
TCP/IP Specifies the TCP/IP settings for the network.
• IP Mode: Dual Stack or IPv4 Mode.
• IPv4: Get IP Address, IP Address, Subnet Mask, or Gateway Address