User Manual

How to identify Genuine Xerox Supplies
When you find the authentication label on Xerox supplies packaging,
please check the following features of the label:
Presence of label, comparable to sample pictured above.•
Serial number printed on right side of label.•
Barcode code printed along bottom edge of label.•
Most importantly, the background changes between four different •
messages, “GENUINE,” “ORIGINAL,” “VÉRITABLE” and “AUTÊNTICO”
at different viewing angles.
Authentication label with the new Xerox logo will be
introduced soon
Xerox will soon introduce the authentication label with our new logo.
For a certain period, there will be 2 types of labels, one with the old logo
and the other with the new logo. Both are genuine Xerox products and
should not be mistaken as counterfeits.
The features to be checked for the authenticity remain the same.
Current products with the label
All solid ink cartons and virtually all toner cartons carry the
authentication label. Some product supplies, such as the Phaser 7300
and 7400 do not have authentication labels and should not therefore
be considered counterfeit.
If you have any reason to doubt the authenticity of any Xerox supplies,
please contact the Reseller from whom you purchased and request an
exchange or refund.
Xerox Authentication Label
Xerox uses an “authentication label” on solid ink and laser toner
packaging to provide customers the peace of mind that they are
getting a genuine product.
The authentication label is a small (3.3 x 1.3 cm) Xerox-branded
holographic label used to verify the authenticity of an item as “Genuine
Xerox.” This label uses multiple levels of security to prevent counterfeiting.
TITLE
AUTHENTIFICATION LABEL
Page
2 of 2
PART NUMBER
335-1162-00
REV
B
FRM-117 Rev 01 DO NOT SCALE DRAWING
Finishing Die Cutting
: 1.3 x 0.5”
Characteristics: Slit Width
: 1.5” (+/- 1/32”)
Core Size
: 3” Diameter
Roll Length
: 10,000 labels (This will result in an approximate roll OD of 7.25”)
Roll Size:
16” Diameter Maximum (Outside Dimension)
Leader:
36 inch of blank line on first section of roll (i.e. no labels)
Splices
: Butt-cut/ no overlaps
Special Option
: Sequential numbering & Barcode (Use only #1,R-510W or #2,CES 1040)
Packaging & Handling Labeling: Per Xerox Standard 063-3462-00, Section 6.0
Requirement: Packaging
: All rolls are individually wrapped to avoid contamination. Rolls are secured in close
fitting cardboard boxes to avoid damage.
Storage: Product should be transported & stored in dry conditions away from direct heat and sunlight. Optimal storage
temperature is 72 degrees F, @ 50% Relative Humidity. Recommended shelf life - 2 years when properly stored. Storage in plastic
bag is recommended
DRAWING NOT TO SCALE
For Reference Only
Xerox Authentication Label:
How to identify genuine Xerox Supplies
Copyright © 2008 Xerox Corporation. All rights reserved. Xerox
®
and the sphere of connectivity design are
registered trademarks in the U.S. and/or other countries. SUPFY-13UC
Current label image
New label image
* Position of label may differ, depending on supply item.
Label background enhanced for illustration purposes.