User's Manual

Table Of Contents

Xerox

Duplex Combo Scanner Maintenance

6-8 User Guide

4. Place the calibration page in the scanner as shown in the following image.

5. The scanner pulls in the calibration page and feeds it slowly through the paper path.

6. When calibration is complete the scanner will clear the calibration page out of the scanner.

Remove the calibration page when the utility prompts you to. Do not forcefully pull the page

out of the scanner, the scanner will release the page when it has fully exited out of the

scanner.

Calibration Error

If there is an error during calibration or if the scanner should disconnect during calibration. The

error will display on-screen. If you see a message that calibration failed, please run the calibration

utility again.

Note: if you attempted to calibrate the scanner with any page other than the calibration page

provided with your scanner, the calibration routine will fail. You will need to power cycle the

scanner, through unplug then re-plug of the USB cable, and then restart the calibration.

Replacing the ADF Pad Assembly

Problems with documents feeding into the ADF is an indication that the pad is wearing thin. The

usage life of the ADF pad varies by what type of documents are generally scanned. Scanning large

batches of heavily textured paper and embossed plastic cards will cause the ADF pad to wear

faster. Large continuous batch scanning will also cause the ADF pad to wear faster. The ADF pad

can be used to scan up to 30,000 pages.

You received a replacement pad in the original scanner box, you can also order a new one.

Replacement parts can be purchased from the Parts & Accessories page for your scanner at