User's Manual

27
PRELIMINARY SUBJECT TO CHANGE
a. Master, Repeater, or Slave (one master per network)
b. Network operation of “point-to-point” or “point-to-multipoint”
c. Network address that is shared by all radios on the network
d. Radio address of this radio (“1” if master)
e. Address of radio upstream (closer to the Master)
f. Address of radio downstream (farther from the Master)
g. Set the data block size sent downstream and upstream
3) Set the RF data rate speed and modulation method
4) Set the transmit power
5) Set the distance between the radios for worst case propagation delay.
LED Display
The radio board has 4 LEDs mounted near the edge that indicate: power applied, transmit in progress,
receive in progress, and a spare for special use.
If the radio is mounted inside the Ethernet enclosure, then the radio LEDs are routed to the enclosure
with the following details. On the right side of the radio enclosure are six LED’s. The three on the left
display the status of the first radio and the three on the right display the status of the second. From top
to bottom, each LED indicates the following:
The first LED (top) turns red when the radio is powered on and will subsequently turn green once the
radio has established a link.
The second LED flashes red when the radio is transmitting data.