Spy Quick Start
Packing list o o o o o o o o o 1X complete rtf spy folded with landing gear off 2X 3300mah 4s lipo black with Xfold lable 1X monitor 1X monitor charger 3X antennas o 1X short air unit o 1X long ground o 1X mushroom 2X landing gear 1X transmitter 1X transmitter charger 1X 2.
Insert the landing gear into the housing mounted on the copter. Using the 2.
You will then want to unfold the copter
Line up and insert a thumb screw top and bottom make sure to use the holes towards the center of the frame as these are the X8 bolts
Sometimes pressure is needed to move the boom so the holes in the boom line up with the holes in the frame (if it is to hard you can file out some on the frame for a nice snug fit being careful not to remove to much) Attach the air end antenna to the VTX at the back of the copter gold threads
Next you will want to install the camera on the gimbal. We recommend go pro 3 or 4 but there are other options in this size that may work.
Be very careful with this plug what cable can tear or break if pulled on or bent sharply It should have a nice loop in it like this
Mounting the batteries with the leads facing the rear of the copter. Rout the wires in to the frame to ensure they don’t come in contact with a prop.
Check out the transmitter quick start guide to set up your transmitter. SUPPLEMENT All instruction manuals, quick start guides, warning notices, and more are available at http://www.xfoldrig.
