Reference Guide

2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
2AS2S-M882E2”. Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user's manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as
shown in this manual.
The module is not applicable for Limited module procedures. The module is a Single module and
complies with the requirement of FCC Part 15.247
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to
FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the receiving
antenna.
FCC ID: 2AS2S-M882E2