Instruction Manual

Trou bleshooti na
This page summarizes the most common problems you could encounter with the
produc
t. If you a 用 unable to solve the problem with the information below,
∞ ntact service center immediately.
If the problem encountered is not listed, please try the following suggestions:
1. Turn
0 忏 the product and unplug i t.
2. Wait for 60 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem
pe 陌 ists ， contact the authorized service center.
Problem Possible Cause Suggestion
Ensure the
vol 国 ge on the
The product The product is not plugged
product ∞ rresponds to the
does not
work
in properly.
local mains voltage and
then plug in again.Make
su 陪 the outlet is properly
working.
The product
Thepn 创 uct has just
If you want another session,
stopped
finished its auto timer
press the Power button
working
session and has
agaln.
automati 但lI y switched to
standby mode.
The product
You
may have used the
Unplug the product and let it
stopped
product continuously
for 45
working
minutes where the over heat
cool down
for 60 minutes
protection has been
before you use
it again.
activated.
The product
Anexlωssive load has been
Reduωthe e~ωssive load
does not
work
applied on the product.
and start again.
The product is
The product is likely to be
Unplug the product an let it
abnormally
。， verused.
∞ 01 down before using it
warm
agaln.
Noise can be
Noise is made by the
This is normal and does not
hea 时 from the
mechanical parts
of the
mean that the product is
product
product.
faulty.
24