Instructions For Use V 3.0 HS420 +1(855) 888-6699 usa@holystone.com (USA) ca@holystone.com (CA) www.holystone.com eu@holystone.com (EU) jp@holystone.
English 01-31
Contents 1.0 Disclaimer & Warning .............................................................................. 01 2.0 Safety Guidelines ....................................................................................... 01 3.0 Maintenance .............................................................................................. 05 4.0 Package Contents ..................................................................................... 06 5.0 Drone Details .........................................
1.0 DISCLAIMER & WARNING 1. Please read this Disclaimer & Warning and Safety Guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. You agree that you are responsible for your own conduct and any damage caused while using this product, and any consequence.
④ Please perform a thorough check of the product before each use. Inspect the integrity of the parts, any signs of cracks and wear off on the propellers, battery power and effectiveness of the indicator, etc. If there is any problem found after checking the drone, please refrain from using it until the problem is resolved. 2.
2.3 Operation Requirements ① DO NOT use this product to follow any moving vehicles. ② During the flight, turn off the motors only in case of an emergency. ③ When the battery runs low, return the drone back to your starting point. ④ DO NOT use this product if you feel tired, take medicine or feel unwell and drink alcohol. ⑤ Be aware of the volume of noise that the drone produces. Please ensure to keep your distance to avoid ear damage. ⑦ DO NOT fly in any spaces where drones are prohibited.
⑦ Only use the USB charging cable that comes with the drone to charge the battery. ⑧ DO NOT connect the battery directly to wall outlets or car cigarette -lighter sockets as this will damage your battery since they have different voltage. ⑨ DO NOT attempt to disassemble or modify the battery in any way ⑩ DO NOT use the battery if it gives off an odor, generates heat, becomes discolored, deformed or appears abnormal in any way.
3.0 MAINTENANCE ① Clean the drone after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone or batteries. ③ This device is not waterproof and must not be submerged or subjected to water under any circumstance. Failure to keep the device completely dry will result in the failure and permanent damage to the unit.
4.0 PACKAGE CONTENTS ×1 Drone ×1 Transmitter ×1 USB Charging Cable ×4 Propellers Gebrauchsanweisung V 3.0 HS420 +1(855) 888-6699 www.holystone.com usa@holystone.com (USA) eu@holystone.com (EU) ca@holystone.com (CA) jp@holystone.
5.
6.
7.0 JOYSTICK MODE 7.1 MODE 2 (Default Setting) Left Joystick Right Joystick Up Ascend Up Forward Down Descend Down Backward Left Right Rotate Left Rotate Right Left Right Fly to Left Fly to Right 7.2 MODE 1 To enter Mode 1, long press the Trimmer button while turn on the transmitter. (Please do not release the Trimmer button until the transmitter is powered on.
8.0 INSTALLATION 8.1 Drone Battery Installation: ② ① As shown in the figure above, install the battery to the buckle on the back of the drone and push it forward. When you hear a click, the battery is installed. Please make sure the battery is securely installed. Removal: ② ① As shown in the figure above, hold down the two sides of the battery and pull it back, then remove the battery upwards.
8.2 Phone Holder ② ① ③ Pic.1 Pic.2 As the shown above, open the phone holder completely (Pic.1). Adjust the mobile phone holder upward and downward according the size of your mobile phone (Pic.2). 9.0 LOW BATTERY WARNING ① When the drone battery runs low, the indicator lights on the drone will blink continuously, and the transmitter will send out beeps continuously. About 1 minutes, the drone will land automatically.
10.0 CHARGING USB Adapter (5V/0.5-2.0A) Power Bank Charging Interface Computer USB Port 1) Connect the battery with the USB charging cable. 2) Plug the USB charging cable into a USB charging port on the computer, power bank or USB adapter (5V/0.5-2.0A ). 3) When the battery is charging, the indicator light on the USB charging cable is red. When the battery is fully charged, the indicator light on the charging cable turns green. 4) The charging time is about 60 minutes.
11.0 OPERATION GUIDE 11.1 Download APP iOS Android APP on Google play Scan the QR code, connect to the App Store™ or Google™ Play and download the “HolyStone-FPV” application for free. Required Operating Systems: iOS 9.0 or later/Android 5.0 or later. 11.2 Connect to Wi-Fi Connect your phone to the Wi-Fi network created by the drone. To check the drone’s status on the ”HolyStone-FPV” App. ① Open your phone’s Wi-Fi settings and click Wi-Fi to search for the Wi-Fi of the drone.
11.3 Pairing All of the following operations on this manual uses MODE 2. ① Long press the Power Switch to turn on the drone, the indicator light of the drone will keep flashing. Long Press Head ② Place the drone on a flat and level surface with the head forward and the tail towards the pilot. ③ Long press the Power Switch to turn on the transmitter, and you will hear the “DiDi” sound, then the indicator lights keep flashing.
11.4 Calibrate the Gyro Simultaneously push the left joystick and the right joystick to the bottom right corner to calibrate the gyro. The indicator lights on the drone will blink quickly and turn solid that indicates the calibration is completed. Tip: To ensure a stable flight, we suggest that the pilot calibrates the gyro every time after pairing the drone and after a crash. 11.5 Auto Takeoff There are two methods to take off the drone.
Method 2: After pairing/calibration, pick up the drone and lay it flat on your palm. Gently toss the drone into air, and it will hover in place. 11.6 One Key Landing Landing During the flight, press the One Key Takeoff/Landing button, the drone will land on the ground automatically.
12.0 FUNCTIONS DETAILS 12.1 Trimmer Long Press F/B Sideways Drift Trim: If the drone tends to drift forward, hold down the Trimmer button and do not release it while pushing the direction joystick down to re-balance the drone. If the drone tends to drift backwards, hold down the Trimmer button and do not release it while pushing the direction joystick up to re-balance the drone.
12.2 Speed Switch This drone comes with 2 speed modes (Low/High). As shown above, push the Speed Switch button to the left, the transmitter sends out “Di” sound, indicating Low Speed. Push the Speed Switch button to the right, the transmitter sends out “DiDi” sound, indicating High Speed. 12.3 Emergency Stop The Emergency Stop function should only be used in case of emergency during the flight to avoid any damage or injury.
12.4 High-Speed Rotation During the flight, short press the High-Speed Rotation button, the transmitter will make a “Di” sound, which indicates that the drone enters the High-Speed Rotation. The drone will exit the High-Speed Rotation function automatically 10 seconds after, and you can also push the direction joystick to any direction to stop the rotation. 12.
12.6 Altitude-hold Function The drone is designed with altitude-hold function so the drone can maintain its altitude after you release the left joystick. (The left joystick will automatically spring back to the middle) 12.7 Take Photo/Record Video Take Photo: Short press the Take Photo/Record Video button, the transmitter sends out “Di” sound, the indicator lights of the drone flashes once, indicating the camera has taken one photo successfully.
12.8 360° Flip 10 Feet When you get familiar with all the functions of the drone, you can try this amazing flip mode. When you fly the drone at least 10 feet, press the Right Joystick on the transmitter, then push the right joystick Forward/Backward or Left/Right, and the drone will do a flip towards the corresponding direction. Tip: This function will perform better when the battery is fully charged.
12.9 Headless Mode Please after you are fully familiar with the Headless Mode function then use this mode, otherwise it is easy to lose the drone and cause unnecessary loss. Head Tail 1. After pairing/calibration, short press the Headless Mode button on the transmitter. The indicator lights of the drone will flash continuously, the transmitter sends out a beep that the drone is in Headless Mode. 2.
Head Head Tail Tail Head Tail Please make the pilot stays facing the same direction as the direction that the head of the drone faces at take-off. While in Headless Mode, pushing the direction joystick forward will make it fly in the direction that the head of the drone faces when it takes off. To make sure the pilot can tell drone's direction, during the flight,we recommend that pilot stays facing the same direction that the drone head faces at take-off.
13.0 SPECIFICATIONS DRONE Model: HS420 Weight: 31g/1.1oz Max Flight Time: 6 minutes (per battery) Motor Model: HS420 Operating Temperature Range: 32° to 104°F (0° to 40°C) Size: 84 x 90 x 34 mm DRONE BATTERY Capacity: 300mAh Voltage: 3.7 V Battery Type: Li-Po Battery Charging Temperature Range: 41° to 104°F (5° to 40°C) Charging Time: 60 minutes (Depends on charging power and remaining battery power) TRANSMITTER Operating Frequency: 2.
CAMERA GAMERA Operating Frequency: 2.
14.0 CONTACT US Please do not hesitate to contact us if you need further support. usa@holystone.com (America) ca@holystone.com (Canada) eu@holystone.com (Europe) jp@holystone.
15.0 GENERAL INFORMATION FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. FOR DRONE: This device should be installed and operated with minimum distance 20cm between the radiator & your body. Ｉ ｎｎｏｖａｔ ｉ ｏｎ， Ｓｃｉ ｅｎｃｅ ａｎｄ Ｅｃｏｎｏｍｉ ｃ Ｄｅｖｅｌ ｏｐｍｅｎｔ Ｃａｎａｄａ （ Ｉ ＳＥＤ） This device complies with ISEDC licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference; and (2) this device must accept any interference.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements ISEDC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre lasource de rayonnement et votre corps.
5. The battery temperature must never exceed 60°C(140°F) otherwise the battery could be damaged or ignited. 6. Never charge the battery on a flammable surface, near flammable products or inside a vehicle(preferably place the battery on a non-flammable and non conductive surface). 7. Never leave the battery unattended during the charging process. Never disassemble or modify the housing’s wiring, or puncture the cells. Always ensure that the charger output voltage corresponds to the voltage of the battery.
Caution 1.The max operating of the EUT is 45°C. and shouldn’t be lower than -10°C. 2.The device complies with RF specifications when the device used at 0mm form your body. 3.Declaration of Conformity. We, Xiamen Huoshiquan Import & Export CO.
