User's Manual

8
2. 2.4GHz wireless mode quick start guide
--To use the scanner on computer
STEP1. Scan the following code “2.4GHz Wireless Mode” to
2.4Ghz wireless mode.
When the light on the top of
the scanner turns green, it means the scanner successfully
changes mode to 2.4GHz
Wireless Mode.
STEP2. Plug the USB receiver in to USB port of your computer, within 30 seconds, scan
the code “match” to pair the scanner with the USB receiver.
Match
Note：30 seconds after the USB receiver is plugged, the scanner cannot match the USB receiver. If the
pairing fails， the scanner will emits sound like “di en”. Please unplug the USB receiver and plug it
again, then scan the code "match "
STEP3. Scan the code “instant upload mode” to set the scanner to instantly upload
the barcode
Instant u
p
load mode
STEP4. Test the scanner using notepad , put the cursor in the blank and then scan a
barcode to see if the barcode comes up.
2.4GHz wireless mode