4G Solar-powered Traffic Sensing Camera User Manual Datasheet All Software &files can be downloaded from https://www.milesight.
Table of Content 1. Package Contents.........………………………………………………………………………............. 2 2. Hardware Overview………………………………………………………………………...................... 3 3. Interfaces.....................................................…………………………………………………. 4 4. Installation........................................................……………………………………………. 4 5. Configuration....................................……………………………………………………………… 8 6. Dimensions................................……………………………………………………………………… 11 7.
1. Package Contents 2. Hardware Overview Lens Light Sensor 4G Solar-powered Traffic Sensing Camera x1 Solar Panel Cable (0.5m) x1 Screwdriver x1 3-Axis Ball Mounting Bracket x1 Screw of Bracket x1 (Optional) USB Type-C Charging Cable x1 Rain Cover IR LEDs Indicator light Solar Charging Interface Strap x2 Screws Interface Panel Installed Backplane Positive Terminal Negative Terminal Screw Packet x1 2 2 1 Warranty Card www.milesight.
Step 2: Fix the backplane in the position where the device is intended to be installed. Multiple installation methods are available depending on the installation location: Ś Mount directly on the wall, or mount on the wall via 3-Axis Ball Mounting Bracket. 3. Interfaces MicroSD/SDHC/SDXC Card Slot On/Off Button Reset Solar Charging Interface Mini SIM Card Slot Wi-Fi Button USB Type-C ʓ Pole Mount with the straps, or Pole Mount with 3-Axis Ball Mounting Bracket and the straps. 4.
Step 3: Loosen the screws of Interface Panel and remove the cover. And remove the Solar Charging Interface cover. Step 5: Cover back the Interface Panel and fix the screws. Step 6: Connect the solar panel to the Solar Charging Interface. Note: 1. The product does not include solar panel. 2. The device has battery inside, when the solar power supply is insufficient, it can be powered by battery; When the battery is low, it can be charged using USB Type-C. Step 4: Insert the SD Card and SIM Card.
Step 7: Connect the device to the Installed Backplane and tighten the fixing screws. The installation is completed. Step 2: Press the Wi-Fi button to enable Wi-Fi of the device. Step 3: Use mobile devices or laptop to connect to the device's Wi-Fi. Note: The Wi-Fi name is SC211_xxxxxx (xxxxxx is the last six bits of the MAC address). 5. Configuration Step 1: Adjust the switch button to On to start the device. Note: 1.
Step 4: Enter the IP address 192.168.1.1 in the browser to log in to the web page of the device and configure the device. 6. Dimensions Note: 1. Default Userame/Password: admin/ms123456 2. The IP address of the device cannot be modified. 3. For more information about how to configure the device, please refer to the User Manuel. 74.2 56.
7. FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
