User's Manual

Step 7: Connect the device to the Installed Backplane and tighten the fixing
screws. The installation is completed.
5. Configuration
1 8 19
www.milesight.com www.milesight.com
Step 2: Press the Wi-Fi button to enable Wi-Fi of the device.
Step 1: Adjust the switch button to On to start the device.
Step 3: Use mobile devices or laptop to connect to the device's Wi-Fi.
Note: The Wi-Fi name is SC211_xxxxxx (xxxxxx is the last six bits of the MAC address).
Note:
1.When the device is being powered on, the indicator in front of the device will blink green
until the device is powered on. And When the device is turned off, the indicator in front of
the device will blink green twice to indicate.
2. The indicator light will be red to indicate when the device cannot be started due to low
power.