Operation Guide BW20 Neckband Hearing Amplifier Xiamen NewSound Technology Co.,Ltd Address: 1st and 2nd Floor, No.13 of Xiangyue Road, Torch Hi-Tech Industrial Development Zone, Xiang'An District, Xiamen, China.
THANKS Congratulations! Welcome to a New Life created by NewSound Neckband Hearing Amplifier. Please read this manual carefully before use. Intended use This instrument is an electronic device which amplifies sounds from the surrounding environment. This new generation neckband TV hearing amplifier enables hearing impaired people enjoy a colorful life. BW20 applies 2.4GHz Wireless data transmission technology, which can work with TV through transmitter.
Configuration 产品 Configuration 产品 ⑦ ⑤ ① ② ④ ⑥ ③ ① ⑤ ③ ④ ② ⑧ ⑨ ⑩ ⑥ BW20 Neckband Hearing Amplifiers, TV hearphones ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩ Multi-function Button Volume Up Volume Down USB Charging Port Receiver (head phone) 02 Indication Light TV002 Remote Microphone USB Cable Adapter Earphone Domes ⑦ TV002 Remote Microphone ① ② ③ ④ ⑤ Microphone ⑥ Wallpost ⑦ 3.5 Audio Cable Power Button Pairing Button Indication Light 3.
How to Use 产品 Indication light guide When paired with TV002, BW20 can make it easier to watch TV, listen to radio and also other sound source from limited distance.
2. How to Use 3. ON and OFF Power Button Multi-function Button 1) As shown above, slightly lift both ends, wear around the neck with volume button upwards and on the left. 2) Insert the earphones into both ears. Please note it is the hearing amplifier mode when turned on. The volume is already set at appropriate level after production. It’s recommended to first adjust volume to your comfortable level. BW20: To turn on: Long press “Multi-function button” for 3-5 seconds to turn on the device.
4. Adjust volume 5. Program Switch ╋ Multi-function Button 9 Volume Up 1 Volume Down ━ As shown above, short press “volume+” to increase volume, short press “volume- ” to decrease volume. Attention: There are a total of nine levels of volume. When reach the minimum volume, you will hear beep sound. When reach the maximum volume, you will hear “Di” sound. As shown above, short press “Multi-function button” to switch among four modes. BW20 provides four pre-setting program modes.
6. Pairing with TV002 remote microphone Short press “Multi-function button” to switch among four modes. BW20 provides four pre-setting program modes. Step 3: Place TV002 near to BW20 within 20cm and wait for 5 seconds. Short press TV002 “Pairing button”, then the indication light on TV002 and BW20 will both shine blue, and the earphone will beep sound to remind Multi-function Button you the pairing is successfully done.
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
