User's Manual

Service Calling System User Manual----English Version
- 25 -
simultaneously on the calling device.
If the service caller and WD1X/PD1X are successfully matched, WD1X/PD1X will
vibrate and the digit on LCD won’t flash any more.
When finish setting, press cancel key [C] to exit.
(2) Delete the number of the calling device (or table number)
After entering the F2 mode, use selection keys [Ç] [È] to select “-Del” and enter it.
LCD displays ‘
---’ without flashing. At this time, the system enters the state of deleting
table number. There are two ways for your reference: 1. delete the table number one by
one; 2. data formatting (delete all table numbers)
z Delete the Table Number One by One
Make the WD1X/PD1X enter the state of delete table number, at the same time, press
key [CALL] and [C] on the SCX Service Caller.
Then the display device shows the corresponding table number, going with flashing
and vibration. Now, please check the number. If it is the number to delete, press key
to confirm. If it is not, press cancel key [C] to exit.
Repeat the operation above can delete the table number one by one.
z Data Formatting
Attention: please pay attention to do this operation, or the deleted data cannot be
found back any more.
Make the WD1X/PD1X enter the state of delete table number, press key
and
hold it until LCD displays ‘-’ cursor. When LCD displays ‘0000’, the system finishes data
formatting. Here, all the table number is deleted.
Press cancel key [C] to exit.