User's Manual

Service Calling System User Manual----English Version

5.4 Setting Wireless Parameters for RF Repeaters

Without PC software, users still could match calling devices with RF repeaters, and set

wireless parameters for RF repeaters.

5.4.1 Ready

Before matching devices, users should get ready the RF repeater, SC2X calling device,

WD1X/PD1X display device.

5.4.2 Enter the Mode of Parameter Setting

1. Press key on the WD1X/PD1X display device to enter the function set. Press [È]

[Ç] key to select F5, and enter it. In this mode, the display device will work as the display

screen of the repeater while setting its parameters. The screen displays as follow:

2. Power on the RF repeater, and within 20 seconds, long press one of the key [WATER] /

[CALL]/ [BILL] on the SC2X calling device to make the repeater directly enter different

mode of parameter setting: [WATER]-set RF repeater code, [CALL]-set shop ID,

[BILL]-match calling devices with RF repeaters. At this moment, the power indicator light

in the repeater flashes slowly.

Note: If the repeater does not enter the setting mode within 20 seconds after being

powered on, the display device will go to normal work.

R E P T

d I S P