User's Manual

Service Calling System User Manual----English Version

5.4.3 Setting of Each Parameter

Note: After entering one of the setting modes (set repeater code/shop ID or match

with calling devices), users could press key [CALL] and [BILL] simultaneously to

switch among these modes. The order of switching: set shop ID-> set RF repeater

code-> match with service calling devices.

5.4.3.1 Set RF Repeater Code

Enter the mode of setting RF repeater code: Press key on the WD1X/PD1X

display device, and then press [È] [Ç] key to select F5, and enter it. Power on the repeater,

and within 20 seconds, long press the key [WATER] for more than 2 seconds. At this

time, the display device vibrates and the power indicator light in the repeater flashes

slowly. The screen display as follow:

Set RF repeater code

: After entering the mode of setting RF repeater code, the RF

repeater code and the symbol “-” flash alternatively. Press [CALL] or [C] key on SC2X to

plus or minus the blinking code. Users could use digit 0~9 or letter A~F to set the code.

The default code is 0.

Confirm the RF repeater code:

After setting the RF repeater code, press key [WATER]

and [BILL] simultaneously to confirm it. And then, the RF repeater code shown on the

display device stops flashing.

5.4.3.2 Set Shop ID

The purpose of setting shop ID for repeaters is to distinguish users’ repeaters from

others in surrounding area, designate shops to repeaters to take service, avoid service

conflict. Therefore, if there is no service conflict, this setting is unnecessary.

R E P T

Here shows the RF

repeater code.