User's Manual

Service Calling System User Manual----English Version
35
Enter the mode of setting shop ID: Press key on the WD1X/PD1X display device,
and then press [È] [Ç] key to select F5, and enter it. Power on the repeater, and within 20
seconds, long press the key [CALL] for more than 2 seconds. At this time, the display
device vibrates and the power indicator light in the repeater flashes slowly. The screen
display as follow:
Set shop ID
: After entering the mode of setting shop ID, the ID and the symbol “-” flash
alternatively. Press [CALL] or [C] key on SC2X to plus or minus the blinking digit. Users
could use digit 0~7 to set shop ID. The default ID is 0.
Confirm the shop ID:
After setting the shop ID, press key [WATER] and [BILL]
simultaneously to confirm it. And then, the shop ID shown on the display device stops
flashing.
5.4.3.3 Match Calling Devices and RF Repeaters
Enter matching mode: Press key on the WD1X/PD1X display device, and then
press [È] [Ç] key to select F5, and enter it. Power on the repeater, and within 20 seconds,
long press the key [BILL] for more than 2 seconds. At this time, the display device
vibrates and the power indicator light in the repeater flashes slowly. The screen display as
follow:
Match calling devices with RF repeaters: After entering the matching mode, press
[WATER] and [BILL] key simultaneously on SC2X to match the calling device with RF
repeater. Then the WD1X/PD1X display device will show the ID of the caller. The screen
S H O P
2
Here shows
the shop ID.
S C I d
0 0 0 0
0 - -