User's Manual

the unit clean and maintained by dusting the components on a regular basis. Cleaning the two

exposed sides of the Running Belt (No. 50) will prevent dust from accumulating underneath. Keep

your running shoes clean so that dirt from the shoes does not wear the Running Board (No. 49)

and Running Belt (No. 50). Clean the surface of the Running Belt (No. 50) using a clean damp

cloth. Keep liquids away from electrical parts and Running Belt (No. 50).

ADJUSTING THE RUNNING BELT

Place the treadmill on level ground and set it at 3.5-5 MPH to check and see if the Running Belt

(No. 50) drifts from the center. Adjust the Running Belt (No. 50) according to instructions below

with Allen Wrench (No. 88).

FOLDING INSTRUCTIONS

NOTE: Please make sure the incline is at

ZERO when folding and unfolding.

1. If the Running Belt (No. 50) drifts to

the right, turn the adjusting bolt on the

right side ¼ turn clockwise, then turn

the left adjusting bolt ¼ turn

counter-clockwise. If the Running

Belt (No. 50) does not move, repeat

this step until it centers. Refer to image

2. If the Running Belt (No. 50) drifts to

the left, turn the adjusting bolt on the

left side ¼ turn clockwise, then turn

the right adjusting bolt ¼ turn

counter-clockwise. If the Running

Belt (No. 50) does not move, repeat

this step until it centers. Refer to image

3. Over time, the Running Belt (No.

50) will loosen. To tighten the

Running Belt (No. 50), turn both the

left & right side adjusting bolts one full

turn clockwise. Check the tension of

the Running Belt (No. 50). Continue

this process until Running Belt (No.

50) is at the correct tension. Make

sure to adjust both sides equally to

ensure even alignment. Refer to

image C.