User's Manual

Backligh
t color selection
To select the LCD backlight color, follow this procedure:
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘LED? 006’(menu 006) is displayed
3. push ENTER;
4. turn the Encoder knob to select AUTO, ON, OFF ;
5. press ENTER
6. press the VFO/MR to exit
Beep on/off
The keypad beep is activated by default. To deactivate it::
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘BEEP? 007’(menu 007) is displayed
3. push ENTER;
4. turn the Encoder knob and activate/deactivate the beep (ON=beep enabled;
OFF=beep disabled);
5. press ENTER
6. press the VFO/MR to exit
Keypad lock setting
To lock the keypad to prevent the wrong operation:
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘KEYBO? 008’(menu 08) is displayed
3. push ENTER;
4. turn the Encoder knob to select AUTO, MANUAL
5. press ENTER
6. press the VFO/MR knob to exit
TOT setting
To prevent continuous emission of the radio, the unit can be set of 30-270
seconds continuous emission limits, a warning tone will be hear in the due time.
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘TOT?’(menu 09) is displayed
3. push ENTER;
4. turn the Encoder knob to select from OFF, 30, 60, 90, 120, 150, 180, 210, 240,
270.
5. press ENTER
6. press the VFO/MR knob to exit
Voice function
With this function, you activate a voice that informs about any
operation/selection you are doing. To activate or select it. Follow these steps:.
1. press the MENU and ENT button;