User's Manual

Scanning instructions and methods
When to start scanning your intercom circulation preprogrammed scan through the list if there is a voice activity
to view the current channel.LED lights flashing for a red light, and the scan icon appears on the screen.
In dual mode during the scan, if you're in a digital channel and your intercom locking an analog channel, will be in
the call of the last period automatically by digital mode switch for the simulation model.And vice versa.
There are two kinds of scanning methods:
Manual scanning: according to the preliminary programming to start scanning for scanning on/key or menu
function, start scanning, interphone will detect the default scan the list of all channel/group.
Automatic scanning: when you select a already activated automatically scan channel/group calls, walkie-talkie
from activated automatically scan channel scan.
Start and stop the scan
According to the preliminary programming scan on/key or enter the scan menu function
1. Use the select a channel knob preprogrammed scan the list of channels;
2. Press [OK] key to enter the menu mode;
3. Press the [delta or del] key to scan, and then press [OK] key choice;
4. If the scanning is disabled, the screen display open or if the scan is activated, the screen shows close;
5. Press [OK] to select.
6. When the scan is activated, the LED indicator lights flashing red light, and display the scan icon;Or when
scanning is stopped, the LED light is put out and does not display the scan icon.
Scanning reply
Scan when radio detection to the active channel/group calls, walkie-talkie stays in the channel/group calls, this is
called "scanning hang time" preprogrammed time limit.
Process:
1. Hold the hand microphones to keep its in a vertical position and with the mouth 1 to 2 inches (2.5 to 5.0
cm).Free prompt if you enable the "channel" function, when launch intercom (PTT) release button, you will
hear a short beep, said this channel is idle, waiting for your answer.
2. In the hang time press (PTT), the LED indicator for the red light.
3. (PTT) release button to answer.
4. If you did not respond, within the time hang the intercom opportunities continue to scan down.
Set up the
Take off the net