User's Manual

2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press the [delta or del] key to radio set, and then press [0 k] key choice.
4. Click [delta or del] key to LED lights, and then press [0 k] key choice.
6. Open screen, press [0 k] enable LDE lights, screen display of LED light is open.
Or screen shows closed, according to the [0 k] button to turn off the LED indicator light, screen display of LED
light is closed.
If stop using the LED indicator light, the screen backlight, buttons and keyboard backlight automatically shut
down.
Open or close boot interface
If you need, you can enable and disable boot interface display.
1. Press [OK] key to enter the menu mode.
2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press the [delta or del] key to radio set, and then press [0 k] key choice.
4. Click [delta or del] key to boot interface, and then press [0 k] key choice.
5. Open screen, press [0 k] enable boot interface display, the screen display boot interface to open.
Or screen shows closed, according to the [0 k] button to turn off the boot interface display, the screen display
boot interface shut down.
Access to radio information in general
Intercom include the following information:
• radio ID
• software version
• Codeplug version
Note: at any time according to the [back] key can return to the previous screen.
Check the intercom ID
1. Press [OK] key to enter the menu mode.
2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press [delta or del] to intercom information, and then press [0 k] key choice.
4. Press [delta or del] to the machine number, then press [0 k] key.
5. The screen interphone ID.
Check the firmware version
According to radio firmware version.
1. Press [OK] key to enter the menu mode.
2. According to the [delta or del] key to set up, and then press [0 k] key choice.
3. Press [delta or del] to intercom information, and then press [0 k] key choice.
4. Click [delta or del] key to the firmware version, and then press [0 k] key.
5. The screen will display the current firmware version.