326 Printer User Manual
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Catalogue CATALOGUE ........................................................................................................................... 3 1、PRODUCT INTRODUCTION ............................................................................................. 4 2、SUMMARY ......................................................................................................................... 5 MAIN F EATURES ..................................................................................................
1、PRODUCT INTRODUCTION 326 series printer is a POS direct thermal receipt printer with easy operation and high cost effective, which is widely used in supermarket, hospital, restaurant, bank, oil station, turnpike etc. Safety Notice Please read carefully and strict compliance with use of following instructions before operating the printer. 1. Safety Warning Warning: Do not touch the cutter of printer.
(9) In order to ensure the printing quality and extend the life of printer, please use the recommendatory thermal paper or the one which has the same quality. (10) Please make sure the power of printer is off when plugging the connecting line. (11) Please keep the user manual for reference when needed.
Serial USB Ethernet Cash Drawer Power Supply Cash Drawer Control：6 lines RJ-11 socket，output: DC24V/1A ● Character ASCII code character set：12×24 dots，1.25（W）×3.00（H）mm Chinese character：24×24 dots，3.00（W）×3.00（H）mm International Codepage: 10 types of international language--- PC437、 Katakana、PC850、PC860、PC863、PC865、WPC1252、 PC866、PC852、 PC858 and so on. Printing Barcode：Supports 9 types of barcode printing, UPC-A、UPC-E、 EAN(JAN)13、EAN(JAN)8、CODE39、CODABAR、ITF、CODE93、 CODE128 and so on.
(3) If the thermal paper is polluted by the chemical or oil, it would fading or decreases the feeling of heat and influence the print result finally. (4) It would result the fading of thermal paper if to use the hard material to chafe the surface. (5) Please pay attention to the temperature, humidity and illumination of the storage for thermal paper. The paper would fade if the storage temperature is over 70 centigrade.
Printer Power supplier Power cord Paper roll CD Commutation cable 2、Printer Connection (1) To ensure the printer and PC is powered off and then insert the matched data connection lines to the interfaces (USB/Parallel/Serial) of the printer, the other ends are to the PC. (2) If the user fit out the electric opened cash drawer for the printer that could insert the RJ-11 connection line of it to the corresponding interface of the printer.
(1) Firstly, insert the power supply plug DC24V of printer; then connect the AC220V power; lastly, turn on the switch. Please operate it by the instruction steps; otherwise, it would damage the printer. (2) Using unsuitable power adapter would cause the bad print result; even may cause the breakdown of printer. (3) Do not connect the telephone line to the interface of cash drawer; because it may result in the damage for printer and telephone. (4) Do not pull the power soft wire when unplugging.
(3) Pull a part of paper out and then close the top cover. (4) Use the cutter of printer to tear off the extra paper 4、Power Switch, Keystroke and Indicator Light 4.1 Power Switch Switch is for turning on/off the power supply of printer which is located on the left. When pressing “-” , the printer turns on and when pressing “O” , it turns off. Notice: Do not turn on the switch unless the user connects the power supply. 4.
FEED Key： In the standby status, the printer would be continuous feed when pressing the feed key. Of course, the key is inefficacy when the printer is working. Press the feed key and switch on the power supply while the key is still under pressing, then the user could do the self-checking of printer. POWER Key（Green）： Light appears continuously when connected to the power supply.
6、Cash Drawer Interface Cash drawer interface adopt RJ-11 standard, 6 lines socket and it outputs DC 24V/1A. Insert the RJ-11 socket to the corresponding interface which could through the printer to open the cash drawer. Pin function of cash drawer interface is listed as below: Pin Number 1 2 3 4 5 6 Flow Direction Empty Empty Electrical grounding Output Empty Empty Driver Signal of Cash Drawer Output Empty Empty Empty Empty Signal 7、Printer Maintenance 7.
7.2 Sensor Maintenance When the printer has following circumstance, the user should clean the paperless sensor: (1) During the printing, the printer occasionally stops print and the paperless alarm is beeping. (2) No paperless alarm. Procedure of maintaining the sensor is listed below： (1) Turn off the power supply and open the top cover. Remove the paper if necessary. (2) Use the cotton cloth and dip it in the absolute ethyl alcohol to clean the surface of sensor.
(4) When the absolute ethyl alcohol is completed volatilized, and then turns on the power to print. 8、Fix the Paper Jam When paper jam happens, turn off the power supply and open the top cover, wait for the cooling of print head then remove the jammed paper. After that, reload the paper roll and close the top cover. Use the recommendatory paper or the one which has the same quality with specified width would reduce the risk of paper jam.
9.2 The indicator light is on, while the printer cannot work Do the self-checking to check whether the printer can work normally. If not, please contact the distributor or technical support. If the self-checking can work, please check the following contents: (1) Check the interfaces of printer and computer and also check whether the connected line between them is to their specification requirement. (2) The setting of data transmission between printer and computer may be different.
