Installation Instruction

Self-ballast LED lamp User Instruction
Ⅰ、Product Features
⚫ Compact structure and design - small, light weight, stylish
⚫ Made with high quality parts and materials - high reliability
⚫ Light-emitting elements and parts produced with new manufacturing
technology – high lumen output
⚫ The LED bulbs can't be used in any dimmable circuit
Ⅱ、Product drawing and dimensions
Model
Input
Power
(W)
CCT（K）
Lamp
cap
TSZ9A19-LD007
120VAC 50/60Hz
9W
RGBCW
E26
Ⅲ、Selection and installation instruction
1. Open product packaging and check if product is intact, contact seller if found
damaged.
2. Check to confirm product rated voltage is same as local power grid voltage.
3. Switch off light power.
4. Hold bulb by plastic housing and install into light socket.
5. Switch on/off as usual when power is connected.
Ⅳ、Warning
1. Do not put in dripping-wet environment.
2. Do not touch bulb when switched on as high surface temperature may
scorch and injure skin.
3. Lumen output drops when bulb is used beyond rated lumen maintenance
period. For better protection of your eyesight, do not use beyond rated
period and replace bulb accordingly.
4. Use in Damp Locations only
.
5. This device complies with Part 15 of the FCC Rules / Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.