ZETA AP ZETA AP 1
ZETA AP Copyright Statement ZiFiSense owns the copyright on this specification. No part of this specification may be reproduced in any form or means, without the prior written consent of ZiFiSense. Disclaimer This specification is preliminary and is subject to change at any time without prior notice. ZiFiSense assumes no responsibility for any errors contained herein. ZiFiSense is not responsible for any patent infringement of third party on its use or as a result of its uses.
ZETA AP Table of Contents Table of Contents.................................................................................................3 1. Product Description........................................................................................ 4 2. Applications.....................................................................................................4 3. Appearance & Interface................................................................................4 4. Device Specifications.......
ZETA AP 1. Product Description ZETA IIoT gateway, supporting LPWAN ZETA protocol, to meet the full range of ZETA sensor device access. Ethernet or Cellular link way to connect to the cloud platform, while supporting sensor data back through BACnet, MODBUS and other protocols. It can be widely used in different industrial data communication scenarios, such as: energy, transportation, municipal, agriculture, etc. 2.
ZETA AP 4. Device Specifications Model No.
ZETA AP 5. Installation 5.1. Installation safety notice It is forbidden to operate with electricity when installing, wiring and dismantling the equipment. Place the equipment in a ventilated place to ensure that the equipment is installed in a dry environment. Avoid placing the equipment in a high temperature or low temperature environment. The installation location of the equipment should be far away from high-voltage cables to avoid electromagnetic interference during operation.
ZETA AP 5.4. Installation steps 1) Confirm the installation hole spacing: the four-corner hole can be used for fixed installation. 2) Use the supporting expansion screws to fix the equipment on the wall of the building. Figure 2: Installation diagram 3) Connect the RF antenna and the 4G antenna. The GPS antenna may not be connected when it is installed in a fixed place in the indoor environment.
ZETA AP 6. System Testing 6.1. Check after power-on After power-on, observe the status of the indicator lights next to the power interface, and note that the lower two indicator lights are enabled. The specific functions are shown in the figure below.。 Figure 4: Schematic diagram of power indicator 6.2. Installation information record After the indicator shows normal, the installation information can be recorded. Including installation location, equipment code, etc.
ZETA AP 7. Common faults and handling Check the power supply to ensure that the gateway is powered normally. Check the antenna, whether the antennas are connected correctly, and whether they are properly tightened. Check the network cable and check if the network cable is properly connected. Check the status light to check whether the two status lights on the gateway core board are normal (one is always on, and one flashes twice in one second) View the platform device status.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
ZETA AP 10
